St190 swing weight removal

Joined
Oct 16, 2021
HCP
7
Local club/country
Uk
Irons
Mizuno mp53 3-pw
Driver
Mizuno st190g 9 degree x stiff
#1
Hi, I recently received an st190 3 wood head which had had its shaft removed but swing weights had been left inside the head, is there a way of removing the weight or is this now set for the bin, any help or advice would be much appreciated, thanks.
 

MTR

Well-Known Member
Joined
Nov 24, 2010
HCP
f0re
Local club/country
EU
Irons
MP-9-11-14-29-37-20
#2
A heavier back weight can be removed if careful (torx & glue) and replaced with the stock 2g. If the head was hot-melted however, you can be in for a messy challenge depending on how it was done. You might get lucky with mineral spirits, Be carefull with stronger solvents or (over)heating, they can break down the heads epoxy.
 
Top Bottom