MX200 Shaft length Swingweight

Foreman

New Member
Joined
Jul 9, 2009
Local club/country
Oppegard Golf Norway
#1
Hi!

I am about to make an order for a MX200 set with 1/2" longer shafts and 1 degree up on the lie. Can anybody please tell which swingweight i should have?

Thanks!
 

unbeatenthisyear

Well-Known Member
Joined
Apr 7, 2009
HCP
4
Local club/country
UK
Irons
MP-64
Driver
JPX Proto
#2
Hello Foreman

We would recommend a standard swing weight which would be around D2.

Also, fyi, for +1/2" length we use lighter heads to allow for the extra "weight" caused by the longer length.

I hope you enjoy the 200s!

Best regards, UTY
 

Foreman

New Member
Joined
Jul 9, 2009
Local club/country
Oppegard Golf Norway
#3
Thanks for quick reply! Really good customer service!

So if i understand correct, when i am going to order +1/2" with 1 degree up, is the head going to be bent og is it ready forged? Also the swingweight will be adjusted with a different head?

I am also going to buy a MX-700 driver 10,5. How many degrees closed is it?

Again, Thank you very much!
 

unbeatenthisyear

Well-Known Member
Joined
Apr 7, 2009
HCP
4
Local club/country
UK
Irons
MP-64
Driver
JPX Proto
#4
Our lighter weight heads are forged to 2 degrees upright (as our most popular requested custom spec is +1/2" and 2 degrees upright). So in your case we would have to move them down one degree. Depending on the model we can carry up to 3 or 4 different head weights to allow for different club lengths, shaft weights and grip sizes/weights. All this is calculated by the factory and our aim is always to try to get as near to a standard swing weight as possible.

As for the driver the 10.5 is going to be somewhere between square and 1 degree closed.

Best regards, UTY

PS I'm glad you like the forum, very happy to be of help to you.
 
Top Bottom