Advice on How to best clean my new Mizuno's

jsizzle

New Member
Joined
Jun 23, 2009
HCP
26
Local club/country
Mitcham
Irons
Mizuno MX100 4-SW
Driver
Srixon
#1
Could somebody please offer some advice on how to best clean my new Mizuno irons. I normally washed my old clubs in warm soapy water, and used an old tooth brush to clean the grooves! This seemed to do the job reasonably well but is there any other advise on how to keep them in as good a condition as possible!

Thanks,
John
 

Minner

Active Member
Joined
May 14, 2009
HCP
12.1
Local club/country
Cornwall
Irons
Titliest AP2s S300 4-PW, Vokey 52, 56 & 60, Talormade R7 3W, 22 Degree rescue
Driver
Mizuno MX-700 10.5 Fujikura stiff
#2
after you've soaked, scrubbed and thoroughly dried them, lay them flat face up on an old towel, spray each one with a quick blast of WD40, then with an old rag rub the oil into the grooves and all over the head and shaft. it'll not only give them a great shine but will provide a little extra protection against rust spots.
 
Top Bottom